Konica Minolta Range 7 3D Scanner

A new era of non-contact 3D scanning & 3D measurement will start with KONICA MINOLTA RANGE7

Konica Minolta Range 7 3D ScannerKONICA MINOLTA RANGE7 noncontact 3D digitizer will open up the possibilities of non-contact 3D measurement by adding further reliability, operability and transportability to Konica Minolta’s reliable optical technologies and AF/AE controls.

New function added – Dark surface mode

The dark surface mode function enables 3D scanning for 3D measurement of Objets with reflectance as low as 2.5% without requiring the use of special darkrooms or spraying of the Objet, achieving the industry’s top level low reflectance performance. With the addition of the dark mode function, ultra-low reflectance surfaces (dark Objets) can be measured without being sprayed, 3d measurement inaccuracies caused by uneven thickness of the sprayed layer can be eliminated. Plus, the work involved in pre-measurement surface preparation (spraying) and post-measurement surface cleaning is also no longer necessary, leading to drastic improvements in work efficiency. Reducing the environmental load since spray and cleaning liquids are not used is also an additional benefit of using this new function.

Field-oriented robust design

with a high accuracy of ±40 µm and a 1.31 million-pixel sensor!

Konica Minolta Range 7 3D Scanner

Utilizing a new 1.31 megapixel CMOS sensor that can detect finely detailed shapes as well as newly designed optics, the RANGE7 achieves the highest level of guaranteed accuracy for a non-contact camera type 3D measurement instrument, with an accuracy of ±40 µm* according to ball bar accuracy testing based on VDI/VDE 2634 guidelines.

In addition, the RANGE7 has been designed with the concept of on-site use, minimizing the influence of instrument tilt, temperature changes, etc. at the time of measurement in order to provide high reliability in actual use environments such as in factories, etc.

Quick two-second scanning and 3D preview function!

Original high-speed processing circuits enable high-speed scanning of approximately 2 seconds per shot. In addition, the RANGE7 is equipped with a 3D preview function that lets users predict the measurement results and check for scan area depth, dead angles, scan problems due to surface conditions, etc. beforehand to greatly reduce scanning mistakes.

Further advanced AF and new measurement algorithm!

TELE and WIDE lenses can be interchanged according to the measurement subject to provide a broad scan range. In addition, the autofocus (AF) function has further advances that only Konica Minolta could provide, with a multifocus mode that automatically shifts the focus position to provide sharp, high-accuracy 3D measurement data and a point AF function that adjusts the focus to the point specified by the user, enabling scanning work to be performed without being concerned with fine positioning of the measurement subject.

Plus, the new sensor and original measurement algorithm provides an expanded dynamic range. Even Objets with gloss, such as metallic surfaces, etc. can be measured.

Compact and lightweight, all-in-one unit weighing less than 15 lbs.

The size and weight of the RANGE7 are both less than 1/2 those of previous models, and the compact, lightweight design enables the camera and controller to be integrated in a single body weighing approximately 15 lbs. to provide high mobility in measurement environments.

In addition, when the optional special stand is used, the RANGE7 can be easily moved about and measurements taken when necessary for stress-free work. (Of course, as with previous models, a tripod can also be used.) Plus, user calibration can be performed with the RANGE7 mounted on the stand.